Cookies
Potřebujeme Váš souhlas k využití jednotlivých dat, aby se Vám mimo jiné mohli ukazovat informace týkající se Vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ÖNORM - Austrian standards
Page 1732
ÖNORM EN ISO 8340 (01/09/2005)
Building construction - Sealants - Determination of tensile properties at maintained extension (ISO 8340:2005)
Available languages: English, German
Available design: electronic design (pdf), Print design
from 58.50 USD more info
ÖNORM EN 835 (01/05/1995)
Heat cost allocators for the determination of the consumption of room heating radiators - Appliances without an electrical energy supply, based on the evaporation principle
Available languages: English, German
Available design: electronic design (pdf), Print design
from 114.20 USD more info
ÖNORM EN ISO 835 (01/07/2007)
Laboratory glassware - Graduated pipettes (ISO 835:2007)
Available languages: English, German
Available design: electronic design (pdf), Print design
from 98.00 USD more info
ÖNORM EN ISO 8351-1 (01/11/1996)
Packaging - Method of specification for sacks - Part 1: Paper sacks (ISO 8351-1:1994)
Available languages: English, German
Available design: electronic design (pdf), Print design
from 74.60 USD more info
ÖNORM EN ISO 8351-2 (01/11/1996)
Packaging - Method of specification for sacks - Part 2: Sacks made from thermoplastic flexible film (ISO 8351-2:1994)
Available languages: English, German
Available design: electronic design (pdf), Print design
from 58.50 USD more info
ÖNORM EN ISO 8362-1 (15/01/2020)
Injection containers and accessories - Part 1: Injection vials made of glass tubing (ISO 8362-1:2018)
Available languages: English, German
Available design: electronic design (pdf), Print design
from 79.70 USD more info
ÖNORM EN ISO 8362-2 (01/06/2024)
Injection containers and accessories - Part 2: Closures for injection vials (ISO 8362-2:2024)
Available languages: English, German
Available design: electronic design (pdf), Print design
from 104.20 USD more info
ÖNORM EN ISO 8362-3 (01/06/2003)
Injection containers and accessories - Part 3: Aluminium caps for injection vials (ISO 8362-3:2001)
Available languages: English, German
Available design: electronic design (pdf), Print design
from 58.50 USD more info
ÖNORM EN ISO 8362-4 (15/11/2011)
Injection containers and accessories - Part 4: Injection vials made of moulded glass (ISO 8362-4:2011)
Available languages: English, German
Available design: electronic design (pdf), Print design
from 74.60 USD more info
ÖNORM EN ISO 8362-5 (01/06/2016)
Injection containers and accessories - Part 5: Freeze drying closures for injection vials (ISO 8362-5:2016)
Available languages: English, German
Available design: electronic design (pdf), Print design
from 84.50 USD more info
Copyright © All rights reserved | This template is made with by Colorlib
