Cookies
Potřebujeme Váš souhlas k využití jednotlivých dat, aby se Vám mimo jiné mohli ukazovat informace týkající se Vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
GB - Chinese national standards
Page 4064
GB/T 4169.15-2006 (08/12/2006)
Components of injection moulds for plastics - Part 15: Flat ejector pin
Available languages: English, Chinese
Available design: electronic design (pdf), Print design
from 190.80 USD more info
GB/T 4169.16-2006 (08/12/2006)
Components of injection moulds for plastics - Part 16: Shouldered ejector pin
Available languages: English, Chinese
Available design: electronic design (pdf), Print design
from 166.80 USD more info
GB/T 4169.17-2006 (08/12/2006)
Components of injection moulds for plastics - Part 17: Ejector sleeve
Available languages: English, Chinese
Available design: electronic design (pdf), Print design
from 166.80 USD more info
GB/T 4169.18-2006 (08/12/2006)
Components of injection moulds for plastics - Part 18: Locating ring
Available languages: English, Chinese
Available design: electronic design (pdf), Print design
from 166.80 USD more info
GB/T 4169.19-2006 (08/12/2006)
Components of injection moulds for plastics - Part 19: Sprue bush
Available languages: English, Chinese
Available design: electronic design (pdf), Print design
from 166.80 USD more info
GB/T 4169.2-2006 (08/12/2006)
Components of injection moulds for plastics - Part 2: Straight guide bush
Available languages: English, Chinese
Available design: electronic design (pdf), Print design
from 166.80 USD more info
GB/T 4169.20-2006 (08/12/2006)
Components of injection moulds for plastics - Part 20: Limit pin
Available languages: English, Chinese
Available design: electronic design (pdf), Print design
from 190.80 USD more info
GB/T 4169.21-2006 (08/12/2006)
Components of injection moulds for plastics - Part 21: Rectangular locating element
Available languages: English, Chinese
Available design: electronic design (pdf), Print design
from 166.80 USD more info
GB/T 4169.22-2006 (08/12/2006)
Components of injection moulds for plastics - Part 22: Round mould opening delayer
Available languages: English, Chinese
Available design: electronic design (pdf), Print design
from 166.80 USD more info
GB/T 4169.23-2006 (08/12/2006)
Components of injection moulds for plastics - Part 23: Rectangular mould opening delayer
Available languages: English, Chinese
Available design: electronic design (pdf), Print design
from 166.80 USD more info
Copyright © All rights reserved | This template is made with by Colorlib
