Cookies
Potřebujeme Váš souhlas k využití jednotlivých dat, aby se Vám mimo jiné mohli ukazovat informace týkající se Vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ČSN - Czech national standards
Page 1366
ČSN 211303 (25/06/1982)
Forming machines. Flat forming presses. Configuration of t-slots and holes for the clamping of forming tools and of holes for ejector pins and ejectors
Available languages: Czech
Available design: Print design
from 8.90 USD more info
ČSN 211305 (25/06/1982)
Forming machines. Flat forming presses. Dimensions of ejector pin and ejector holes
Available languages: Czech
Available design: Print design
from 5.70 USD more info
ČSN 211306 (25/06/1982)
Forming machines. Flat forming presses. Dimensions of stem holes in rams
Available languages: Czech
Available design: Print design
from 5.70 USD more info
ČSN 211402 (20/04/1971)
Forming machines. Connecting dimensions for mould clamping on presses for products made of thermosetting plastics
Available languages: Czech
Available design: Print design
from 3.00 USD more info
ČSN 211410 (17/02/1970)
Clamping of dies. Basic regulations
Available languages: Czech
Available design: Print design
from 5.70 USD more info
ČSN 211411 (17/02/1970)
Forming machines. Clamping of dies for spindle presses below 100 mp
Available languages: Czech
Available design: Print design
from 10.70 USD more info
ČSN 211412 (17/02/1970)
Forming machines. Clamping of dies for spindle presses below 1000 mp
Available languages: Czech
Available design: Print design
from 5.70 USD more info
ČSN 211413 (17/02/1970)
Forming machines. Clamping of dies for drop and steam-air hammers
Available languages: Czech
Available design: Print design
from 8.90 USD more info
ČSN 211414 (17/02/1970)
Forming machines. Clamping of dies for reversible hammers
Available languages: Czech
Available design: Print design
from 10.70 USD more info
Copyright © All rights reserved | This template is made with by Colorlib
