Cookies
Potřebujeme Váš souhlas k využití jednotlivých dat, aby se Vám mimo jiné mohli ukazovat informace týkající se Vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Active standard | Published: 20/04/1999
ASME B18.25.3M-98:1999(R2008)
Square and Rectangular Keys and Keyways: Width Tolerances and Deviations Greater than Basic Size
Available languages: English
Available design: electronic (protected pdf), Print design
from 42.00 USD
show on eshop
Detail information
Designation: ASME B18.25.3M-98:1999(R2008)
Publication date: 20/04/1999
Pages: 16
Country: American technical standard
Where to buy?
You can buy at www.mystandards.bizAnotation
This standard covers requirements for square and rectangular parallel keys and keyways intended for both alignment of shafts and hubs, and transmitting torque between shafts and hubs. Keys covered by this standard have a relatively loose width tolerance. All width tolerances are positive. Keys with minus width tolerances and a smaller tolerance range are covered by ASME B18.25.1M. The inclusion of dimensional data in this standard is not intended to imply that all sizes described are production stock items. Consumers should consult with suppliers concerning lists of stock items. See moreReaffirmed: 2008
Popular Publishers
DIN standards
BS standards
ASTM standards
ISO standards
IEC standards
Copyright © All rights reserved | This template is made with by Colorlib
