ASTM D5973-97(2025)

Detail information

Designation: ASTM D5973-97(2025)

Publication date: 01/05/2025

Pages: 3

Country: American technical standard

Where to buy?

You can buy at www.mystandards.biz

Anotation

This specification covers the material requirements for preformed elastomeric strip seals and the corresponding steel locking edge rail used in expansion joint sealing. The scope of this specification is limited to preformed non-reinforced strip seals that mechanically lock into structural steel locking lugs. The sealing element can consist of a single layer strip or have multiple webs depending on individual project requirements. When used on highway bridges, limits on maximum joint opening and minimum steel thicknesses need to be addressed. The adhesive-lubricant used to install the preformed seal into the steel locking edge rail shall be a one part moisture curing polyurethane compound. The elastomeric seals shall conform to the physical properties prescribed for (1) tensile strength, (2) elongation at break, (3) hardness, (4) oven aging, (5) oil swell, (6) ozone resistance, (7) low temperature stiffening, and (8) compression set. Requirements for preformed elastomeric seal dimensions, sampling, and test methods to determine compliance with the specified physical properties are given.


Keywords:
adhesive-lubricant, elastomeric, expansion joint, joint sealing, locking edge rails, preformed elastomer, strip seals, vulcanized elastomer,, ICS Number Code 83.140.50 (Seals)