IEEE/IEC 63004-2015

Detail information

Designation: IEEE/IEC 63004-2015

Publication date: 30/12/2015

Pages: 161

Country: International technical standard

Where to buy?

You can buy at www.mystandards.biz

Anotation

Adoption Standard - Active.
A mechanical and electrical specification for implementing a common interoperable mechanical quick-disconnect interconnect system for use by industry for interfacing large numbers of electrical signals (digital, analog, RF, power, etc.) is provided. These large interface panels (receiver and fixture panels) are employed primarily in test systems between stimulus/measurement assets and a related unit-under-test (UUT), although any application involving high-density contacts requiring a quick disconnect interface could benefit. The receiver is a receptacle that is mounted to test system mates with multiple fixtures, which serve as the
buffer between the UUT and automatic test equipment (ATE). Fixtures translate standard input/output (I/O) signal routing offered at the receiver to a wiring interface that directly connects to the UUT. These UUT interfaces can represent cable connectors, direct plug-in (printed circuit board edge connectors), sensor monitoring, or manual feedback from the test technician.
The primary objectives of this standard are: (a) to establish interface standards that permit interchangeability of mechanical/electrical receiver/fixture/connector product assemblies from various manufacturers under an open architecture; and (b) to develop within this framework a defined set(s) of interconnecting connector and mechanical specifications that supports available, accepted, low-cost commercial technology to reduced dependence on proprietary designs and extend life-cycle availability.

ISBN: 978-1-5044-0581-2, 978-1-5044-0607-9
Number of Pages: 161
Product Code: STD20743, STDPD20743
Keywords: connector, fixture, framework, interface, interoperability, mass-interconnect, quick disconnect, receiver, specification
Category: Metrology and Standards