Cookies
Potřebujeme Váš souhlas k využití jednotlivých dat, aby se Vám mimo jiné mohli ukazovat informace týkající se Vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Active standard | Published: 24/04/2019
ISO 12129-2:2019-ed.2.0
Plain bearings — Tolerances — Part 2: Tolerances on form and position and surface roughness for shafts and thrust collars
(Paliers lisses — Tolérances — Partie 2: Tolérances de forme et de position et rugosité de surface des arbres et collets de butée)
Available languages: English
Available design: electronic design (pdf), Print design
from 1 389.10 CZK
show on eshop
Detail information
Designation: ISO 12129-2:2019-ed.2.0
Publication date: 24/04/2019
Pages: 5
Country: International technical standard
Where to buy?
You can buy at www.mystandards.bizAnotation
Description / Abstract: This document specifies tolerances on form and position as well as the surface roughness of shafts, flanges and thrust collars as used in plain bearing units. It is applicable to journal or thrust plain bearing units or to a combination of both, installed either horizontally or vertically. This document is not applicable to crankshaft bearing units in combustion engines.Popular Publishers
DIN standards
BS standards
ASTM standards
ISO standards
IEC standards
Copyright © All rights reserved | This template is made with by Colorlib
