Active standard | Published: 15/07/1999

ISO 12714:1999

Non-destructive testing — Acoustic emission inspection — Secondary calibration of acoustic emission sensors
(Essais non destructifs — Contrôle par émission acoustique — Étalonnage secondaire des capteurs d´émission acoustique)

Available languages: English

Available design: electronic design (pdf), Print design

from 148.00 USD show on eshop

Detail information

Designation: ISO 12714:1999

Publication date: 15/07/1999

Pages: 16

Country: International technical standard

Where to buy?

You can buy at www.mystandards.biz

Anotation

Description / Abstract: This International Standard specifies a method for the secondary calibration of acoustic emission sensors as receivers of elastic waves at the surface of a solid medium. The International Standard is applicable to laboratory tertiary standard sensors and acoustic emission applications sensors. The secondary calibration yields the frequency response of a sensor to waves of a type normally encountered in acoustic emission work, namely Rayleigh waves. The source producing the signal used for the calibration is mounted on the same surface of a test block as the sensor under test (SUT). The sensitivity of the sensor is determined for excitation within the range of 100 kHz to 1 MHz. Sensitivity values are usually determined at frequencies approximately 10 kHz apart. The units of the calibration are volts per unit of mechanical input (displacement, velocity or acceleration).

Popular Publishers

full catalog