Active standard | Published: 25/04/2002

ISO 16063-12:2002

Methods for the calibration of vibration and shock transducers — Part 12: Primary vibration calibration by the reciprocity method
(Méthodes pour l´étalonnage des transducteurs de vibrations et de chocs — Partie 12: Étalonnage primaire de vibrations par méthode réciproque)

Available languages: English

Available design: electronic design (pdf), Print design

from 175.00 EUR show on eshop

Detail information

Designation: ISO 16063-12:2002

Publication date: 25/04/2002

Pages: 20

Country: International technical standard

Where to buy?

You can buy at www.mystandards.biz

Anotation

Description / Abstract: This part of ISO 16063 specifies the instrumentation and procedures to be used for primary calibration of accelerometers using the reciprocity method and the SI system of units. It is applicable to the calibration of rectilinear accelerometers over a frequency range of 40 Hz to 5 kHz and a frequency-dependent amplitude range of 10 m/s2 to 100 m/s 2 and is based on the use of the coil of an electrodynamic vibrator as the reciprocal transducer. Calibration of the sensitivity of a transducer can be obtained using this part of ISO 16063 provided that the signal conditioner or amplifier used with the transducer during calibration has been adequately characterized. In order to achieve these measurement uncertainties, it has been assumed that the transducer has been calibrated in combination with its signal conditioner or amplifier (the combination of which in this part of ISO 16063 is referred to as the accelerometer).

Popular Publishers

full catalog