Active standard | Published: 01/06/2019

SAE AIR1108A

Groove Design - Metal Face Seal

Available languages: English

Available design: electronic design (pdf), Print design

from 74.30 USD show on eshop

Detail information

Designation: SAE AIR1108A

Publication date: 01/06/2019

Pages: 0

Country: American technical standard

Where to buy?

You can buy at www.mystandards.biz

Anotation

Groove designs presented herein are applicable for use with machined or formed metal seals which are similar in configuration to those shown in figure 3, which operate under internal pressure or in vacuum service and which have been specifically qualified or recommended by the purchaser or the manufacturer for use with this AIR. They are also applicable for use with metal o-rings (e.g., MS9142, MS202 thru MS9205) where interchangeability with machined or formed metal seals is desired. For metal o-ring groove designs where inter-changeability is not a requirement refer to ARP 674.

SUBFILE: Aerospace
TYPE OF DOCUMENT: Aerospace Standard

Stabilized: Jun 2019 SAE - Standards Status Definitions