Active standard | Published: 01/03/1989

SAE ANSIB92.2M

Metric Involute Splines and Inspection Standard

Available languages: English

Available design: electronic design (pdf), Print design

from 173.80 EUR show on eshop

Detail information

Designation: SAE ANSIB92.2M

Publication date: 01/03/1989

Pages: 0

Country: American technical standard

Where to buy?

You can buy at www.mystandards.biz

Anotation

This standard provides data and guidance for the design, manufacture, and inspection of straight, non-helical, cylindrical involute splines. It establishes a specification based on the metric module within the range 0.25-10 inclusive, relating to nominal pressure angles of 30 deg, 37.5 deg, and 45 deg. For computer programming, the term "37.5 deg" has been adopted instead of "37 deg, 30 min".

Limiting dimensions, variations, and manufacturing tolerances and their effect on the fit between connecting co-axial spline elements, are defined and tabulated. Linear dimensions are expressed in millimeters and micrometers. Angular dimensions are expressed in degrees and decimal degrees.

SUBFILE: Automotive
TYPE OF DOCUMENT: Ground Vehicle Standard

Popular Publishers

full catalog