Active standard | Published: 01/07/2015

SAE EIA408

Interface between Numerical Control Equipment and Data Terminal Equipment Employing Parallel Binary Data Interchange

Available languages: English

Available design: electronic design (pdf), Print design

from 115.50 EUR show on eshop

Detail information

Designation: SAE EIA408

Publication date: 01/07/2015

Pages: 0

Country: American technical standard

Where to buy?

You can buy at www.mystandards.biz

Anotation

This standard applies to the interconnection of data terminal equipment and numerical control equipment at the tape reader interface. The data terminal would typically be connected to a remote data source/sink such as a computer.

This standard defines:

This standard is applicable for the interchange of signals when used in conjunction with electronic equipment, each interchange circuit of which has a single return (signal ground) that can be interconnected at the interface point.

Figure 1.1, typical installation, shows how this standard should be applied to a typical tape reader interface of numerical control equipment.

SUBJECT TAXONOMY: Architecture, Electronic equipment, Computer software and hardware
SUBFILE: Aerospace
TYPE OF DOCUMENT: Aerospace Standard

Stabilized: Jul 2015 SAE - Standards Status Definitions