Cookies
Potřebujeme Váš souhlas k využití jednotlivých dat, aby se Vám mimo jiné mohli ukazovat informace týkající se Vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Active standard | Published: 01/12/2015
SAE J1604
Rubber Boots for Drum-Type Hydraulic Brake Wheel Cylinders
Available languages: English
Available design: electronic design (pdf), Print design
from 78.20 USD
show on eshop
Detail information
Designation: SAE J1604
Publication date: 01/12/2015
Pages: 0
Country: American technical standard
Where to buy?
You can buy at www.mystandards.bizAnotation
This SAE Standard covers molded rubber boots used as end closures on drum-type wheel brake actuating cylinders to prevent the entrance of dirt and moisture, which could cause corrosion and otherwise impair wheel brake operation.
The document includes performance tests of brake cylinder boots of both plain and insert types under specified conditions and does not include requirements relating to chemical composition, tensile strength, or elongation of the rubber compound. Further, it does not cover the strength of the adhesion of rubber to the insert material where an insert is used.
The rubber material used in these boots is classified as suitable for operation in a temperature range of ?40 to +120 °C ± 2 °C (?40 to + 248 °F ± 3.6 °F).
SUBJECT TAXONOMY: Brake cylinders, Brake seals, Elastomers
SUBFILE: Automotive
TYPE OF DOCUMENT: Ground Vehicle Standard
Popular Publishers
DIN standards
BS standards
ASTM standards
ISO standards
IEC standards
Copyright © All rights reserved | This template is made with by Colorlib
