Active standard | Published: 01/10/2019

SAE J2535

Setting Preload in Heavy-Duty Wheel Bearings

Available languages: English

Available design: electronic design (pdf), Print design

from 77.10 EUR show on eshop

Detail information

Designation: SAE J2535

Publication date: 01/10/2019

Pages: 0

Country: American technical standard

Where to buy?

You can buy at www.mystandards.biz

Anotation

This SAE Recommended Practice applies to the four primary, large volume applications in the class 7-8 heavy-duty market place, as specified in SAE J1842:
a
“N” trailer axle

b
“R” powered rear axle

c
“FF / FG” nonpowered front axle

d
“P” trailer axle

This document applies to on-highway applications. It is not applicable to those applications that exceed the GAWR ratings or the load line restrictions listed in columns “A,” “B,” and “C” of Table 1. Load lines are measured from the inboard bearing cup backface as shown in 3.4.

This document establishes preload force values only. The methodology to obtain these force values must be determined by the fastener supplier and/or axle assembler.

This document reviews the bearing system. It is NOT intended to prescribe (new or existing) axle and/or hub manufacturers’ ratings and/or specifications.

SUBFILE: Commercial Vehicle
TYPE OF DOCUMENT: Ground Vehicle Standard

Stabilized: Oct 2019 SAE - Standards Status Definitions