Cookies
Potřebujeme Váš souhlas k využití jednotlivých dat, aby se Vám mimo jiné mohli ukazovat informace týkající se Vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Active standard | Published: 01/03/2023
SAE J2812
Road Load Tire Model Validation Procedures for Dynamic Behavior
Available languages: English
Available design: electronic design (pdf), Print design
from 113.90 USD
show on eshop
Detail information
Designation: SAE J2812
Publication date: 01/03/2023
Pages: 0
Country: American technical standard
Where to buy?
You can buy at www.mystandards.bizAnotation
This SAE Recommended Practice describes an evaluation procedure for validating tire models for use in road load simulations and assesses the relevant dynamic behavior of tires.
The laboratory test utilized is a “cleat” test, where a rolling tire on a drum encounters a cleat and the resulting dynamic forces and moments are measured. This test is described in SAE J2730, “Dynamic Cleat Test with Perpendicular and Inclined Cleats”. The test is commonly used to identify tire model parameters.
In this recommended practice, requirements for the measurement of the tire’s response are described along with data processing techniques and calculations used to quantitatively compare the tire model’s calculated response to the tire’s response measured on test. This recommended practice addresses both the tire model structure and its parameters.
SUBFILE: Automotive
TYPE OF DOCUMENT: Ground Vehicle Standard
Popular Publishers
DIN standards
BS standards
ASTM standards
ISO standards
IEC standards
Copyright © All rights reserved | This template is made with by Colorlib
