Cookies
Potřebujeme Váš souhlas k využití jednotlivých dat, aby se Vám mimo jiné mohli ukazovat informace týkající se Vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Active standard | Published: 01/11/2016
SAE J485
Holes in Bolt and Screw Shanks and Slots in Nuts for Cotter Pins
Available languages: English
Available design: electronic design (pdf), Print design
from 74.30 USD
show on eshop
Detail information
Designation: SAE J485
Publication date: 01/11/2016
Pages: 0
Country: American technical standard
Where to buy?
You can buy at www.mystandards.bizAnotation
SAE J485 specifies the recommended nominal diameters and locations of holes in bolt or screw shanks, and nominal widths and depths of slots in nuts, for use with the recommended sizes of inch-series cotter pins, as shown in Table 1.
SUBJECT TAXONOMY: Drilling, Parts, Fasteners
SUBFILE: Automotive
TYPE OF DOCUMENT: Ground Vehicle Standard
Stabilized: Nov 2016
Popular Publishers
DIN standards
BS standards
ASTM standards
ISO standards
IEC standards
Copyright © All rights reserved | This template is made with by Colorlib
