Active standard | Published: 01/09/2020

SAE J617

Engine Flywheel Housing and Mating Transmission Housing Flanges

Available languages: English

Available design: electronic design (pdf), Print design

from 81.60 EUR show on eshop

Detail information

Designation: SAE J617

Publication date: 01/09/2020

Pages: 0

Country: American technical standard

Where to buy?

You can buy at www.mystandards.biz

Anotation

This SAE Standard specifies the major dimensions and tolerances for Engine Flywheel Housings and the Mating Transmission Housing Flanges. It also locates the crankshaft flange face or the transmission pilot bore (or pilot bearing bore) stop face in relation to housing SAE flange face.

This document is not intended to cover the design of the flywheel housing face mating with the engine crankcase rear face or the design of housing walls and ribs. Housing strength analysis and the selection of housing materials are also excluded.

This document applies to any internal combustion engine which can utilize SAE No. 6 through SAE No. 00 size flywheel housing for mounting a transmission.

SUBFILE: Automotive
TYPE OF DOCUMENT: Ground Vehicle Standard

Stabilized: Sep 2020 SAE - Standards Status Definitions