Active standard | Published: 01/01/1971

SAE J65A

SPECIFICATIONS AND METHODS OF TEST FOR RUBBER BOOTS FOR USE ON DRUM TYPE HYDRAULIC BRAKE WHEEL CYLINDERS

Available languages: English

Available design: electronic design (pdf), Print design

from 1 563.20 CZK show on eshop

Detail information

Designation: SAE J65A

Publication date: 01/01/1971

Pages: 0

Country: American technical standard

Where to buy?

You can buy at www.mystandards.biz

Anotation

These specifications cover molded rubber boots used as end closures on drum type wheel brake actuating cylinders to prevent the entrance of dirt and moisture which could cause corrosion and otherwise impair wheel brake operation.

The specifications include performance tests of brake cylinder boots of both plain and metal insert types under specified conditions and do not include requirements relating to chemical composition, tensile strength, or elongation of the rubber compound. Further, they do not cover the strength of the adhesion of rubber to metal in the insert type.

The rubber material used in these boots is classified as suitable for operation in a temperature range of ?40 to +120 ±2 C (?40 to +248 ±3.6 F).

SUBJECT TAXONOMY: Automobiles
SUBFILE: Automotive
TYPE OF DOCUMENT: Ground Vehicle Standard

Popular Publishers

full catalog