ASTM D7472-19(2024)

Podrobné informace

Označení: ASTM D7472-19(2024)

Datum vydání: 01.04.2024

Stran: 4

Země: Americká technická norma

Kde koupit?

Můžete zakoupit na eshop.normservis.cz

Anotace

This specification addresses the physical properties of melt processible molding and extrusion materials of EFEP-fluoropolymer, wherein the EFEP resin is a copolymer of ethylene, tetrafluoroethylene, and hexafluoropropylene. It does not cover blended and recycled materials. Covered here are two types of fluoropolymer that is supplied in pellet form and classified according to their melting points, while the resins of each type are divided into one to two grades in accordance with their melt flow rates. The materials shall be sampled in accordance with an adequate statistical sampling procedure and shall conform to specific gravity, melting point, melt flow rate, elongation, tensile strength, and dielectric constant and dissipation factor requirements when tested by the procedures itemized herein.


Keywords:
copolymer of ethylene, tetrafluoroethylene, and hexafluoropropylene, EFEP copolymer, ETFE copolymer, ethylene copolymer, ethylene-tetrafluoroethylene copolymer, fluoropolymer, tetrafluoroethylene copolymer, TFE copolymer,, ICS Number Code 83.080.20 (Thermoplastic materials)