Cookies
Potřebujeme Váš souhlas k využití jednotlivých dat, aby se Vám mimo jiné mohli ukazovat informace týkající se Vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Aktivní norma | Vydána: 01.05.2011
SAE J683
Tire Chain Clearance - Trucks, Buses (Except Suburban, Intercity, and Transit Buses), and Combinations of Vehicles
Dostupné jazyky: Anglicky
Dostupné provedení: Elektronické PDF, Tištěné
od 64.40 EUR
zobrazit na eshopu
Podrobné informace
Označení: SAE J683
Datum vydání: 01.05.2011
Stran: 0
Země: Americká technická norma
Kde koupit?
Můžete zakoupit na eshop.normservis.czAnotace
The purpose of this SAE Information Report is to set up a guide as to body, frame, and wheel housing clearance to accommodate tire chains, and also the minimum bogie spacing to permit using chains on both axles. These dimensions apply to trucks, buses, and combinations of vehicles 10 001 lb (4535.06 kg) GVW and over, and are based upon recommendations of the Tire and Rim Association and of the National Association of Chain Manufacturers. The diagram shows clearance for chains over the tire ONLY and allowance must be made for spring deflections in determining fender clearance. See Figure 1 and Table 1.
SUBJECT TAXONOMY: Tires and traction, Vehicles, Trucks, Buses
SUBFILE: Commercial Vehicle
TYPE OF DOCUMENT: Ground Vehicle Standard
Stabilized: May 2011
Populární vydavatelé
DIN normy
BS normy
ASTM normy
ISO normy
IEC normy
Copyright © All rights reserved | This template is made with by Colorlib
