Cookies
Potřebujeme Váš souhlas k využití jednotlivých dat, aby se Vám mimo jiné mohli ukazovat informace týkající se Vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
STN - Slovak standards
Page 4746
STN EN ISO 294-1 (01/08/2001) Withdrawn
Plastics. Injection moulding of test specimens of thermoplastic materials. Part 1: General principles, and moulding of multipurpose and bar test specimens
Available design: Print design
STN EN ISO 294-2 (01/08/2001) Withdrawn
Plastics. Injection moulding of test specimens of thermoplastic materials. Part 2: Small tensile bars
Available design: Print design
STN EN ISO 294-3 (01/03/2004) Withdrawn
Plastics. Injection moulding of test specimens of thermoplastic materials. Part 3: Small plates
Available design: Print design
STN EN ISO 294-3 (01/08/2001) Withdrawn
Plastics. Injection moulding of test specimens of thermoplastic materials. Part 3: Small plates
Available design: Print design
STN EN ISO 294-3 (01/08/2004) Withdrawn
Plastics. Injection moulding of test specimens of thermoplastic materials. Part 3: Small plates (ISO 294-3:2002)
Available design: Print design
STN EN ISO 294-4 (01/03/2004) Withdrawn
Plastics. Injection moulding of test specimens of thermoplastic materials. Part 4: Determination of moulding shrinkage
Available design: Print design
STN EN ISO 294-4 (01/07/2004) Withdrawn
Plastics. Injection moulding of test specimens of thermoplastic materials. Part 4: Determination of moulding shrinkage (ISO 294-4:2001)
Available design: Print design
STN EN ISO 294-4 (01/08/2001) Withdrawn
Plastics. Injection moulding of test specimens of thermoplastic materials. Part 4: Determination of moulding shrinkage
Available design: Print design
STN EN ISO 294-5 (01/07/2018) Withdrawn
Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy (ISO 294-5:2017)
Available design: Print design
STN EN ISO 294-5 (01/09/2013) Withdrawn
Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy (ISO 294-5:2011)
Available design: Print design
Copyright © All rights reserved | This template is made with by Colorlib
