STN - Slovenské národní normy

Plastics. Injection moulding of test specimens of thermoplastic materials. Part 1: General principles, and moulding of multipurpose and bar test specimens

Dostupné prevedenie: Tlačené

Plastics. Injection moulding of test specimens of thermoplastic materials. Part 2: Small tensile bars

Dostupné prevedenie: Tlačené

Plastics. Injection moulding of test specimens of thermoplastic materials. Part 3: Small plates

Dostupné prevedenie: Tlačené

Plastics. Injection moulding of test specimens of thermoplastic materials. Part 3: Small plates

Dostupné prevedenie: Tlačené

Plastics. Injection moulding of test specimens of thermoplastic materials. Part 3: Small plates (ISO 294-3:2002)

Dostupné prevedenie: Tlačené

Plastics. Injection moulding of test specimens of thermoplastic materials. Part 4: Determination of moulding shrinkage

Dostupné prevedenie: Tlačené

Plastics. Injection moulding of test specimens of thermoplastic materials. Part 4: Determination of moulding shrinkage (ISO 294-4:2001)

Dostupné prevedenie: Tlačené

Plastics. Injection moulding of test specimens of thermoplastic materials. Part 4: Determination of moulding shrinkage

Dostupné prevedenie: Tlačené

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy (ISO 294-5:2017)

Dostupné prevedenie: Tlačené

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy (ISO 294-5:2011)

Dostupné prevedenie: Tlačené