Active standard | Published: 30/11/2017

ISO 21307:2017-ed.3.0

Plastics pipes and fittings — Butt fusion jointing procedures for polyethylene (PE) piping systems
(Tubes et raccords en matieres plastiques — Modes opératoires d´assemblage par soudage bout a bout de tubes et raccords en polyéthylene (PE))

Available languages: English

Available design: electronic design (pdf), Print design

from 148.10 USD show on eshop

Detail information

Designation: ISO 21307:2017-ed.3.0

Publication date: 30/11/2017

Pages: 16

Country: International technical standard

Where to buy?

You can buy at www.mystandards.biz

Anotation

Description / Abstract: ISO 21307:2017 establishes general principles regarding the procedure used in the construction and quality assessment of butt fusion jointing of polyethylene (PE) piping system components specified in accordance with relevant ISO standards. These components are installed in accordance with the relevant codes of practice, national regulations or industry guidance. Specifically, this document specifies three butt fusion jointing procedures for PE pipes and fittings. These are: - single low-pressure fusion jointing procedure; - dual low-pressure fusion jointing procedure; - single high-pressure fusion jointing procedure. ISO 21307:2017 takes into consideration the materials and components used, the fusion jointing procedure and equipment and the quality assessment of the completed joint. It can be applied in conjunction with appropriate national regulations and standards.

Popular Publishers

full catalog