Aktívna norma | Vydaná: 30.11.2017

ISO 21307:2017-ed.3.0

Plastics pipes and fittings — Butt fusion jointing procedures for polyethylene (PE) piping systems
(Tubes et raccords en matieres plastiques — Modes opératoires d´assemblage par soudage bout a bout de tubes et raccords en polyéthylene (PE))

Dostupné jazyky: Anglicky

Dostupné prevedenie: Elektronické PDF, Tlačené

od 148.10 USD zobraziť na eshopu

Podrobné informácie

Označenie: ISO 21307:2017-ed.3.0

Dátum vydania: 30.11.2017

Stránok: 16

Krajina: Medzinárodná technická norma

Kde kúpiť?

Môžete zakúpiť na eshop.normservis.sk

Anotácia

Description / Abstract: ISO 21307:2017 establishes general principles regarding the procedure used in the construction and quality assessment of butt fusion jointing of polyethylene (PE) piping system components specified in accordance with relevant ISO standards. These components are installed in accordance with the relevant codes of practice, national regulations or industry guidance. Specifically, this document specifies three butt fusion jointing procedures for PE pipes and fittings. These are: - single low-pressure fusion jointing procedure; - dual low-pressure fusion jointing procedure; - single high-pressure fusion jointing procedure. ISO 21307:2017 takes into consideration the materials and components used, the fusion jointing procedure and equipment and the quality assessment of the completed joint. It can be applied in conjunction with appropriate national regulations and standards.

Populárna vydavatelia

celý katalóg